To avoid damaging the components of a printed circuit board when testing it with a DC volt-ohmmeter, you should ()
- Aground the board
- Bavoid reversing the polarity of the leads
- Cisolate sensitive components with heat sinks
- Dall of the above
To avoid damaging the components of a printed circuit board when testing it with a DC volt-ohmmeter, you should ()
1、The objective of shoring a damaged bul
The objective of shoring a damaged bulkhead is to().Aforce the warped, bulged, or deformed sections back into placeBsupport and hold the area in the damaged positionCwithstand subaequent additional damagedDmake a watertight seal at the damaged area
2、The four basic components of a fire ar
The four basic components of a fire are fuel, heat, oxygen and a chain reactionWhich of the following statements best describes what must be ...
3、The objective of shoring a damaged bul
The objective of shoring a damaged bulkhead is to().Aforce the warped,bulged,or deformed sections back into placeBsupport and hold the area in the damaged positionCwithstand subsequent additional damageDmake a watertight seal at the damaged area
4、In the event of damage to the DEEP WAT
In the event of damage to the DEEP WATER SHIP which results in flooding to one of the lower-hull tanks,pump from().Anearby damaged tanksBnearby undamaged tanks containing ballastCtanks on the opposite cornerDthe opposite trim tank
5、The damage to a vessel is over $25,000
The damage to a vessel is over $25,000. Who must notify the nearest Coast Guard Marine Safety or Marine Inspection Office as soon as possible?()AThe Master of the vesselBThe Radio OfficerCThe Chief OfficerDAll of the above
6、The ()is not a component of an oil sep
The ()is not a component of an oil separator.Asliding bowl bottomBgravity discCseparating discDscum valve