In the manufacture of wire rope，if the wires are shaped to conform to the curvature of the finished rope before they are laid up，the rope is called（）.
- Acomposite
- Bleft-lay
- Cimproved
- Dpreformed
问题
In the manufacture of wire rope，if the
参考解析：
分类：SOLAS公约的有关内容题库
相关推荐
-
1、If the length of a wire is halved and
If the length of a wire is halved and the cross-sectional area is doubled, the resistance will be （）AquarteredBunchangedCdoubledDquadrupled
-
2、The coil of wire rotating in the magne
The coil of wire rotating in the magnetic field produces the（）.AvoltageBcurrentCpowerDfrequency
-
3、On your vessel，a wire rope for the car
On your vessel，a wire rope for the cargo gear shows signs of excessive wear and must be replaced. In ordering a new wire for this 10-ton boom，what safety factor should you use?（）AThreeBFiveCSixDSeve
-
4、If water is rising in the bilge of a l
If water is rising in the bilge of a lifeboat，you should FIRST（）.Aabandon the survival craftBcheck for cracks in the hullCshift all personnel to the sternDcheck the bilge drain plug
-
5、In a combination chain and wire rope m
In a combination chain and wire rope mooring system，the anchor chain is deployed at the anchor end of the line to（）.Aincrease fatigue life of the systemBreduce the time to retrieve the lineCincrease the holding powerDreduce the catenary
-
6、If water is found in the crankcase of
If water is found in the crankcase of a diesel engine, the cause may be due to（）Aa cracked cylinder headBa leaky cylinder head gasketCa cracked cylinder linerDany of the above