The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
- A Switch1(config)# i nterface fa0 /1 Switch1(config-if)# ip address 192.168.24.3.255.255.255.0
- B Switch1 (config)#interface fa0/1 Switch1 (config-if)# switchport mode trunk
- C Switch 1 (config)# i nterface fa0 /1 Switch1 (config-if)# duplex full Switch1 (config-if)# speed 100
- D Switch1 (config-if)# default-gateway 192.168.24.1
- E Switch1 (config)# line con 0 Switch1(config-line)# password cisco Switch1 (config-line)#logi