可学答题网 > 问答 > CCNP(642-902)题库
目录: 标题| 题干| 答案| 搜索| 相关
问题

Refer to the exhibit. You have comple


Refer to the exhibit. You have completed an OSPF implementation, and you are verifying OSPF operation. You notice that router A and router B are stuck in the two - way state. From the show ip ospf interface command output, what is the cause of this issue?()

  • A All OSPF implementations must have at le ast one interface in area 0.
  • B You are attempting to run in the broadcast mode over an NBMA interface.
  • C Both routers are configured to function as a BDR; therefore, there is no DR router.
  • D Someone has changed the OSPF router ID; therefore you must clear the OSPF process.
  • E The OSPF priority is set to 0 on both routers; therefore neither can become the DR.
参考答案
参考解析:
分类:CCNP(642-902)题库
相关推荐

1、Refer to the exhibit

Refer to the exhibit. Which two statements are true about the partial configuration tha...

2、Refer to the exhibit

Refer to the exhibit. A router has a 256 kbps Frame Relay circuit connected to&#8...

3、Refer to the exhibit. You want to min

Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco...

4、Refer to the exhibit. You want to use

Refer to the exhibit. You want to use all the routes in the EIGRP topology for IP load balancing. Which two EIGRP subcommands wou ld you use to accomplish this goal?()A traffic - share balancedB distanceC maximum- pathsD default - networkE variance

5、Refer to the exhibit. According to th

Refer to the exhibit. According to the routing table, where will the router send a packet destined for 10.1.5.65?()A10.1.1.2B10.1.2.2C10.1.3.3D10.1.4.4

6、Refer to the exhibit. When you examin

Refer to the exhibit. When you examine the routing table of R1 and R4, you are not able to see the R1 Ethernet subnet on the R4 routing t...